Revell Model Kit

What's the best glue to use on a Revell model kit?

I'm about to embark on a model kit, by Revell.

I've never done one before, so I'm not sure. I've heard of poly cement, but never used it.

Is there a "best one" & is it waterproof (eg: it got rained on after the model was completed)

Ideally answers from UK, as I'm not sure if other countries (like USA) have slightly different glues.

Thanks a lot!!

Revell kits are usually made from a styrene based plastic.
Styrene plastic is not glued it is welded.
Testors and others make the acetone-based solvent.
Procedure:
Test fit all parts, sanding or filing where necessary to ensure a good fit.
Remove all excess plastic (flash) from the part.
Carefully place a minimal amount of the solvent only on the edge surfaces to be welded. Wait 30 seconds. Reapply. You have about 30 seconds to position the parts and hold them together for 45 seconds to a minute to allow the solvent to evaporate, and the parts to weld together.
Because the acetone evaporate, it is best to use it only in a well-ventilated place.
This solvent will not work with resin kits.

Audi R8 Revell 1/24 scale model kit (building review)

Incoming search terms:

• model fire engine revell
• rc airplane ford tri motor kit
• revell 1/24 gmc pick up w/snow plow
• revell plane assembly
• revell wasp radial engine